519-896-6399
1-866-300-5122
Email


Home | Solar Film | Domes | Mirrors - Convex  Dome | AshtraysHeadsets | Security Hardware | Screen | CameraQuote

Examples of Competitor's Products:


Commercial | Designer | Examples  |  FAQ | Residential | Solar Films


This is an example of a competitor's inexperienced installation and poor quality materials

This is an example of a competitor's inexperienced installation and poor quality materials

  • This is a competitor's product at a local store.
  • The circled areas show where the product is starting to peel off the glass due to heat build up on the window.
  • POOR QUALITY Products that cannot stand up to the Suns Heat and UV Rays result in failed protection, poor visibility and money wasted!
  • What's Protecting Your Glass?
  • These are examples of all other films with cheap prices and poor warranties.
  • Have you seen cars with bubbling and delaminating? That is a result of cheap product and poor warranties. These are the same films that are being put on buildings.
  • Get the best the first time and not worry about having to strip the defective films off and paying again in 2-5 years.

This is an example of a competitor's inexperienced installation and poor quality materials This is an example of a competitor's inexperienced installation and poor quality materials

This is an example of inexperienced installation and poor quality materials


This is an example of a competitor's inexperienced installation and poor quality materials

This is an example of a competitor's inexperienced installation and poor quality materials


Causes of Competitor's Product Failure

  • Bubbles:
    • Bubbles form when remaining moisture collects.
    • After a period of curing time and sunlight, the moisture will evaporate and disappear.  If the film was not installed properly air pockets will form and the glue will separate from the film  and the de-lamination process has begun.
    • Eventually all of the film will separate from the glue and you will then have total material break down.
    • All of our technicians have been factory trained to follow installation steps very carefully so this will never happen.
 
  • Fingering:
    • This problem is caused by poor installation.
    • Material was cut too large or was not trimmed properly.
    • After the material has fully cured it has no room to expand or contract.
    • The film then begins to separate from the glue and the edges begin to peel away from the glass.
 
  • Total Material break down:
    • In most cases the quality of the product is the cause.
    • The heat build-up on the glass area can reach temperatures of 110 to 120 degrees.  Poor construction and poor quality film cannot withstand the heat generated on the glass and the film combined.
    • The film separates from the glue and starts to bubble.  This turns the film layer into tinsel paper and leaves a yellowing layer of glue.  This glue layer is all that is left to protect you from the heat and UV rays.  It obviously gives you no security protection at all!


Commercial | Designer | Examples  |  FAQ | Residential | Solar Films


Home | Solar Film | Domes | Mirrors - Convex  Dome | AshtraysHeadsets | Security Hardware | Screen | CameraQuote


Request a Quote    |     Email     |     Toll Free: 1-866-300-5122  |  About Us

Copyright 2007 FacilityManagement.ca.  Text, graphics and photos are protected by
Canadian and International Copyright Laws and may not be copied, reproduced, published, translated,
hosted, or otherwise distributed by any means without prior written permission.

E.&O.E. - Specs subject to change and will be confirmed at time of quote or ordering.